H.R. 3825 (ih) To amend the National Labor Relations Act to ensure that the National Labor Relations Board does not decline to assert jurisdiction over the horseracing and dogracing industries. ...

	Web GovRecords.org

                                                       Calendar No. 498
105th CONGRESS
  2d Session
                                H. R. 3824

                          [Report No. 105-267]


_______________________________________________________________________


                   IN THE SENATE OF THE UNITED STATES

                             June 18, 1998

                                Received

                             June 24, 1998

  Read twice and referred to the Committee on Commerce, Science, and 
                             Transportation

                             July 27, 1998

                Reported by Mr. McCain, with amendments
  [Omit the part struck through and insert the part printed in italic]

_______________________________________________________________________

                                 AN ACT


 
 Amending the Fastener Quality Act to exempt from its coverage certain 
 fasteners approved by the Federal Aviation Administration for use in 
                               aircraft.

    Be it enacted by the Senate and House of Representatives of the 
United States of America in Congress assembled,

SECTION 1. AMENDMENT.

    Section 15 of the Fastener Quality Act (15 U.S.C. 5414) is 
amended--
            (1) by inserting ``(a) Transitional Rule.--'' before ``The 
        requirements of this Act''; and
            (2) by adding at the end the following new subsection:
    ``(b) Aircraft Exemption.--
            ``(1) In general.--The requirements of this Act shall not 
        apply to fasteners specifically manufactured or altered for use 
        on an aircraft if the quality and suitability of those 
        fasteners for that use has been approved by the Federal 
        Aviation Administration, except as provided in paragraph (2).
            ``(2) Exception.--Paragraph (1) shall not apply to 
        fasteners represented by the fastener manufacturer as having 
        been manufactured in conformance with standards or 
        specifications established by a consensus standards 
        organization or a Federal agency other than the Federal 
        Aviation Administration.''.

SEC. 2. DELAYED IMPLEMENTATION OF REGULATIONS.

    The regulations issued under the Fastener Quality Act by the 
National Institute of Standards and Technology on April 14, 1998, and 
any other regulations issued by the National Institute of Standards and 
Technology pursuant to the Fastener Quality Act, shall not take effect 
until after the later of June 1, 1999, or the expiration of 120 days 
after the Secretary of Commerce transmits to the Committee on Science 
and the Committee on Commerce of the House of Representatives, and to 
the Committee on Commerce, Science, and Transportation of the Senate, a 
report on--
            (1) changes in fastener manufacturing processes that have 
        occurred since the enactment of the Fastener Quality Act; 
        <DELETED>and
        </DELETED>    (2) a comparison of the Fastener Quality Act to 
        other regulatory programs that regulate the various categories 
        of fasteners, and an analysis of any duplication that exists 
        among programs; and
            <DELETED>(2) </DELETED>(3) any changes in that Act that may 
        be warranted because of the changes reported under 
        <DELETED>paragraph (1). </DELETED>paragraphs (1) and (2).
The report required by this section shall be transmitted to the 
Committee on Science and the Committee on Commerce of the House of 
Representatives, and to the Committee on Commerce, Science, and 
Transportation of the Senate, by February 1, 1999.
                                     





                                                       Calendar No. 498

105th CONGRESS

  2d Session

                               H. R. 3824

                          [Report No. 105-267]

_______________________________________________________________________

                                 AN ACT

 Amending the Fastener Quality Act to exempt from its coverage certain 
 fasteners approved by the Federal Aviation Administration for use in 
                               aircraft.

_______________________________________________________________________

                             July 27, 1998

                        Reported with amendments

Other Popular 105th Congressional Bills Documents:

Other Documents:

105th Congressional Bills Records and Documents